knurled screw for sale, brand-new and used.

15BF6201 up for sale is a new knurled od screw in indiactor tip point , great quality appears to be heat treated and nice smooth radius tip, the total length is 0.439 the major od is 0.192 , the thread od is 0.1095 the threaded area is 0.188 long this thread appears to be a #3 x 56 pitch thread?

Alina Indicator Tool Holding Stand W/Case See Description This is a Tool holding Stand that consists of a Base with a 3/8” Hole for a Rod & a Locking Knurled Thumb Screw , & Wood storage Case that needs Repair (Hinges are bad. Combine Wins & Save Shipping $$$$$. Have FUN BIDDING & GOOD LUCK “Check out my other items!”   Hi my name is David;        WHERE APPLICABLE I will COMBINE SALES  “Please E-Mail me & I will Hold your items until your done bidding” .

Up for sale in a complete Mituttoyo in side micrometer set. Mitutoyo 141-122 Vernier Inside Micrometer &n

Starrett 440Z-6L Vernier Depth Gauge, Lock Nut, Micrometer Type, 0-6" Range, 0.001" Graduation, 2.5" Base, 6 Rods, 0.0001" Accuracy The Starrett 440Z Vernier Depth Gauges, Lock Nut (no Ratchet Stop), Micrometer Type,

Scribers are steel, properly tempered and well finished. The points are finely tapered so that the scriber point can be easily seen on the work. The handle, as well as the points, have a knurled grip.

I offer many sizes and styles of protractors, both digiatl an analog from 7" up to 24". Click HERE to view my full selection!! This verni

(On Products over $75) General 1702 Pro-Angle 6" Stainless Steel Digital Protractor New - Factory Authorized Distributor - Factory Warranty Large, easy-to-read display. Absolute and Relative measurements. 6" (150mm) Stainless Steel Protractor Arm.

For auction two L.S. Starrett machinist tools - A No. 20 three inch precision machinist square from L.

Starrett 453EZ Inch Reading Diemakers Square Complete With

Up for auction are Center Heads for Combination Square Sets of any Brand for a 1" grooved steel rule with NEW SPI Locking Clamp Screws! These are the same Center Heads as I sell on my other advertisement, but these Center Heads sell with NEW SPI Locking Clamp Screws installed. SPI is well known in the measurement tool Industries for High Quality Precisio

This item is being re-listed because the previous buyer changed the ship to address 3 times and wanted it shipped to an address different from the one shown on his PayPal account. We will ship only to a Paypal Confirmed address. This auction is for one very hard-to-find Derbyshire Mass.

This is a Starrett No.278 V-Block Set with Clamps, 1" Diameter Capacity, Numbered Matched Pair, Hardened and ground, 1-1/4" Square, 1-5/8" in Length. The V's are ground central, parallel and square to the ends and sides. The block has a tapped hole through the side so that it may be attached to an angle plate by a 1/4-20 thread.

Up for auction: Two Starrett 161-B Toolmakers' Parallel Clamps with maker marking "The L.S. Starrett Co. , Athol Mass U.S.A., No..