St-link/v2 Debugger / Programmer For All Stm8 And Stm32 Controller

US $27.00

  • Baasdorf, Germany
  • Feb 13th
ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32 The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.  STM8 applications use the USB full speed interface to communicate with STMicroelectronic’s ST Visual Develop (STVD) or ST Visual Program (STVP) software.  STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments. Features: 5 V power supplied by a USB connector USB 2.0 full speed compatible interface USB standard A to mini B cable SWIM specific features 1.65 V to 5.5 V application voltage supported on SWIM interface SWIM low-speed and high-speed modes supported SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed SWIM cable for connection to the application via an ERNI standard vertical connector (ref: 284697 or 214017) or horizontal connector (ref: 214012) SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector JTAG/serial wire debugging (SWD) specific features 1.65 V to 3.6 V application voltage supported on the JTAG/SWD interface and 5 V tolerant inputs JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector JTAG supported SWD and serial wire viewer (SWV) communication supported Direct firmware update feature supported (DFU) Status LED which blinks during communication with the PC Operating temperature 0 to 50 °C Delivery as shown: 1. ST-Link/V2 2. USB Cable 3. Connection Cable for STM8 SWIM and STM32 JTAG/SWD Protocol 4. Quick-Start sheets for Keil, IAR, Atollic etc
Condition:
New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...
Brand STMicroelectronics
MPN STLink/V2

Directions

Similar products from Maintenance & Supporting Tools for Electronic Components

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies