Little Electric Water Flow Heater Dafi 4.5 Kw 240v- Under Sink

GBP 59.99

  • London, London, United Kingdom
  • Jan 29th
  DAFI Water Heaters - Nominal Power All auctions              Economical and instantaneous hot water supply system      DAFI heater has been designed to heat water within a decentralised system, thus complying with the general rules of technological progress. The central heating of water is implemented, like in the 19 Century, by one large steam engine, providing heat for the whole shop floor.                                                             Installations                                                       Dafi water heater with a connector - Nominal Power        Water Heater Dafi is also available in different range of power:   DAFI Water Heaters - Nominal Power      We sell on this site: Electric Water Heater DAFI 4.5 kW 240V with pressure connection Power: 4,5 kW 240V (4500W) Nominal voltage [V]: 1/N/PE~240V 50Hz Nominal current [A]: 19,6 Automaticfuse [A]: 20                                           Certificates                                            NOTES ON INSTALLATION OF DAFI WATER HEATERS DAFI energy saving water heaters can be installed above, or under your basin or sink. Shower installations are also possible, but never inside the shower cubicle. Installation of your water heater in the ceiling or behind the wall, or in a cupboard next to the shower should be considered.   DAFI water heater Installation Requirements: 1. DAFI water heaters must be installed as close to the point of use as possible to minimise pipeline heat loss. 2. Water pressure must not be less than 60kPa (0.6 bar) and not exceed 600kPa (6bar). If water pressure is too high, a pressure reducing valve must be installed. 3. Water quality e.g. mains supply, borehole, river etc. Should water quality be suspect, a filter must be installed. 4. Single phase or 3 phase power supply with own isolator switch must be available as close as possible to point of usage.   DAFI water heater Installation Procedure: Installing the DAFI energy saving water heater is not complicated, but it needs to installed by a professional plumber and electrician for problem-free operation.   Water supply: • To be undertaken by a qualified Plumber • Incoming water supply should be clean and without any suspended solids or organic materials. • The "static" incoming cold water supply pressure to be accurately measured to ascertain operating conditions. • The maximum operating pressure of all DAFI Heater models is 600 kPa (6 Bar). • A suitable Pressure Reducing Valve is to be installed before the heater unit, should this 600 kPa limit be exceeded. • Heater manifold nut assembly must only to be tightened with the spanner supplied in each box. • All air to be vented from the heater unit prior to connecting the 240 volt or 400 volt 50 Hz power supply. • A cut-off valve should be installed on the water inlet line to the DAFI heater. • All heater units for under sink installation can be installed at any angle.   Recommendations: • Installing a composite pipe from your DAFI water heater to the point of usage will further reduce heat loss and save more energy. • For optimum performance enhancement Spray Nozzle provided should be attached to tap. For models 3.7 kW & 4.5 kW Spray Nozzle is highly recomended. Spray Nozzle spread water and rise pressure of hot water. • Beware of over tightening , use plastic key provided. Do not use metal spanner! • For performance see table FT - flow/temperature   Tips: 1.Each installation is indywidual. Performance of Dafi Heater depends on: voltage drop, temperature of cold water, pressure , type of taps, distance of instalation from point of use, etc. Selection of right power should be done by experienced and competent trade person. 2. Before you buy check if obtained flow corresponds to your demands.   Electric supply: To be undertaken by a qualified Electrician 1. Each heater unit is to be wired to the Distribution Board via the existing Earth Leakage System. Minimum 3 core cable sizes* - 2.5mm2 for 3.7 kW & 4.5kW (240V) - 4 mm2 or 2x2.5mm2(ring) for 5.5 kW & 7.3kW - (240V) - 2.5mm2 for 7.5kW these models is two phase no neutral -(400V) - 4 mm2 9 kW & 11kW these models are two phase no neutral -(400V) *size of cable need to be confirmed with installation method and voltage drop 2. Models 7.5 kW - 11kW are non-domestic unles three phase supply system in property. Any combination of two phases no neutral (eg brown/black=400V). 3. A dedicated suitably sized breaker to be installed on the Distribution Board for each heater unit. 4. A suitable sized 2 pole electric isolator (not fuse spur) to be installed. 5. DAFI heater units are not to be connected to the electrical supply by standard BS 1363 wall plug.   Instructions for first use: 1) before connecting the DAFI heater into electrical grid water must low through the heating element for approx 1 min.      It must be done by turning the hot water knob on.  (pic. 1,2) 2) the unit is now ready to be connected to electricity, provided the above mentioned action has been performed. (pic. 3)   Instructions for use in case of water shortages: 1) disconnect the heater from electrical grid 2) before reconecting the DAFI heater into electrical grid water must low through the heating element for approx 1 min.      It must be done by turning the hot water knob on. (pic. 1,2) 3) the unit is now ready to be reconnected to electricity, provided the above mentioned action has been performed. (pic. 3)         Please feel free to email me with any questions saintbestmedia@gmail.com Pictures and text used in this listing are the property of company that produces the DAFI water heaters and they come from promotional materials published by that company for commercial purposes.     DAFI Water Heaters on eBay All auctions    Business seller information SaintBest Media Contact details 50 Brunswick Park Road London London N111JJ United Kingdom Return policy To qualify for a hassle-free return, you must pay with PayPal and have the item shipped to a US address. The item must be returned in the same condition it was received. See terms and conditions - opens in a new window or tab. After receiving the item, open a return within Return shipping 14 days You pay return shipping
Condition:
New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...
Brand Dafi
MPN Water Heater Dafi 4.5 kW 230V

Directions

Similar products from Other Wiring Accessories and Switches

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies