Digital Touch Sensor Capacitive Touch Switch Module Diy For Arduino Us Seller

US $0.99

  • Seattle, Washington, United States
  • Feb 25th
Features: Low power consumption Power supply for 2 ~ 5.5V DC Can replace the traditional touch of a button Four M2 screws positioning holes for easy installation The module is based on a touch-sensing IC (TTP223B) capacitive touch switch module. In the normal state, the module output low, low power consumption; When a finger touches the corresponding position, the module output high, if not touched for 12 seconds, switch to low-power mode. Specification: Item Min Typical Max Unit Power supply voltage VCC 2 3 5.5 V Output high VOH - 0.8VCC - V Output low VOL - - 0.3VCC V Output Pin Sink Current (@ VCC = 3V, VOL = 0.6V) - 8 - mA Output pin pull-up current (@ VCC = 3V, VOH = 2.4V) - 4 - mA Response time (low power mode) - - 220 mS Response time (touch mode) - - 60 mS Size 24x24x7.2 mm Weight 2 g

Directions

Similar products from Electrical Tool Sets & Kits

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies