3d Printer K-type Ad597 Temperature Control Board Module Ultimaker New M

US $2500

ShenZhen, China
Jun 20th

Open on mobile:
QR code

3D Printer K-type AD597 Temperature Control Board Module Ultimaker New M Advantages: 1 , each one will do functional testing. 2 , especially with a 3Pin 70cm connection for easy connection to the ramps1.4 use . 3 , the official wiki design a diode D1 ( to prevent reverse power ) , resulting in a pressure differential between the two sides of the ground , so that the thermocouple output signal Sg, to the motherboard rear end becomes Sg + Vs, so will lead to temperature allowed, our version using 0 ohm resistor in place of the diode temperature measurement more accurate. Special note: 1 , and the official version is not fully consistent , revised official version of the differential problem , with 0 ohm resistor instead of a diode D1 . 2 , due to low production , small welding difficulty , using manual welding. Suitable for : ramps1.4 and Ultimaker , etc. can be used. Package Included: 1 x 3D Printer AD597 K-type Thermocouple Temperature Control Board Module Ultimaker Payment Shipping Refund We accept PayPal only. But we only Accept your Ebay Address,Please Make sure it's 100% right. Payment must be received in 5 business days of auction closing. Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order. Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched. Fill your shipping info All package need to wait 30 days(US only need 7-10 days),Please take care it.Less than 30 days,we can't take a refund. If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it. If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item. On Apr-15-16 at 06:35:18 PDT, seller added the following information: