100 Turns Calibration Coil For Clamps Who Won't Fit Into Fluke 5500a/coil

US $225.00

  • CANTON MAGOG, QC, Canada
  • Jan 29th
100 turns calibration coil It can be useful to calibrate small clamps that cannot fit into the larger Fluke 5500A/COIL or also used to measure small current into a circuit. It can be added to a pc board to easily measure low current into a circuit. You a can either measure AC or DC current if you use an AC / DC clamp.  IMPORTANT Reading on the clamp Maximum input current : 3 A DC ( 300 A ) 1.5 A 60 Hz ( 150 A ) 1 A 200 Hz ( 100 A ) 0.5 A 500 Hz ( 50 A ) Because of the wire gauge and the impedance, Exceeding these values will turn my Fluke 5500A clalibrator into protection mode showing: "Compliance voltage exceeded" These values might be different using other calibrator brand and model. To avoid damaging the coil, it cannot be used continuously when the input current is over than 1 amp. we recommand a 30 sec. to 1 min duty time followed by a cool down period time This is for the 1 coil only, clamps or calibrator are not included Sold "AS IS" No return

Directions

Similar products from Process, Temperature & Pressure Calibrators

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies