10 Cubic Inch 160 Cc Pto Hydraulic Drive Motor

US $2500

  • Frederick, Illinois, United States
  • Jun 9th
 This is a Young PowerTech YMSY hydraulic motor for a PTO drive. This could be used on the aux hydraulic system of a Skid Steer tractor to drive the PTO shaft output to run a 7-8 ft mower deck or post hole auger. The output shaft is 1-3/8 inch 6 spline with groove retainer ring ( normal farm tractor size). I bought a skid steer adaptor unit equipped with this motor to drive a bushog mower. The motor is for a 25 gallon per minute input and I have a 15 GPM so this is way to big. I have used it about 3 hours trying to figure out why it goes so slow. Finally decided my skid steer is 15 gpm. not 25 gpm. The motor is like new.     This motor would require about 25 gpm, up to 3200 psi input. Output would be  about 35 horse power. Max speed rating of this motor is 800 rpm. The bolt mount pattern is 3 x 3 inches. It uses 1/2 inch bolts to mount. Center pilot circle is 3.25 inch dia.  The suction and discharge ports are a SAE 7/8 inch fine thread with o-ring seal. You can buy these fittings at the local farm to tractor stores to adapt to 1/2 inch pipe or hose. The motor will run clockwise or counterclockwise. $225. FREE SHIPPING
Condition:
New other (see details): A new, unused item with absolutely no signs of wear. The item may be missing the original packaging, or in the original packaging but not sealed. The item may be a factory second, or a new, unused item with defects. See the seller’s listing for full details and description of any imperfections. ...
Brand Young PowerTech
Model YMSY 160cc

Directions

Similar products from Hydraulic Engines

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies